Created
May 25, 2020 11:03
-
-
Save notjosh/dc0fe81ad4c94da78d26461251d71d43 to your computer and use it in GitHub Desktop.
BERG Bridge boot log
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Script started on Mon May 25 12:54:57 2020 | |
command: screen /dev/cu.usbserial-1440 115200 8N1 | |
[?1049h[!p[?3;4l[4l>[4l[?1h=[0m(B[1;59r[H[2J[H[2JRomBOOT | |
Start AT91Bootstrap... | |
U-Boot 2012.04.01 (Sep 18 2012 - 14:24:35) | |
CPU: AT91SAM9G20 | |
Crystal frequency: 18.432 MHz | |
CPU clock : 396.288 MHz | |
Master clock : 132.096 MHz | |
DRAM: 32 MiB | |
WARNING: Caches not enabled | |
NAND: 256 MiB | |
In: serial | |
Out: serial | |
Err: serial | |
Net: macb0 | |
macb0: Starting autonegotiation... | |
macb0: Autonegotiation complete | |
macb0: link up, 10Mbps full-duplex (lpa: 0xd1e1) | |
Hit any key to stop autoboot: 1 0 | |
NAND read: device 0 offset 0xa0000, size 0x200000 | |
Skipping bad block 0x00140000 | |
2097152 bytes read: OK | |
## Booting kernel from Legacy Image at 20800000 ... | |
Image Name: Linux-2.6.36.4 | |
Image Type: ARM Linux Kernel Image (uncompressed) | |
Data Size: 1734152 Bytes = 1.7 MiB | |
Load Address: 20008000 | |
Entry Point: 20008000 | |
Verifying Checksum ... OK | |
Loading Kernel Image ... OK | |
OK | |
Starting kernel ... | |
Uncompressing Linux... done, booting the kernel. | |
Linux version 2.6.36.4 (nick@buildbot) (gcc version 4.6.3 (Buildroot 2013.02-dirty) ) #1 Wed Apr 24 18:01:13 BST 2013 | |
CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177 | |
CPU: VIVT data cache, VIVT instruction cache | |
Machine: Atmel AT91SAM9G20-EK | |
Memory policy: ECC disabled, Data cache writeback | |
Clocks: CPU 396 MHz, master 132 MHz, main 18.432 MHz | |
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128 | |
Kernel command line: console=ttyS0,115200 root=/dev/mtdblock6 mtdparts=atmel_nand:128k(bootstrap)ro,256k(uboot)ro,128k(env1),128k(env2),2M(linux),16M(config),-(root) rw rootfstype=jffs2 runmode=standard | |
PID hash table entries: 128 (order: -3, 512 bytes) | |
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) | |
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) | |
Memory: 32MB = 32MB total | |
Memory: 28968k/28968k available, 3800k reserved, 0K highmem | |
Virtual kernel memory layout: | |
vector : 0xffff0000 - 0xffff1000 ( 4 kB) | |
fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB) | |
DMA : 0xffc00000 - 0xffe00000 ( 2 MB) | |
vmalloc : 0xc2800000 - 0xfee00000 ( 966 MB) | |
lowmem : 0xc0000000 - 0xc2000000 ( 32 MB) | |
modules : 0xbf000000 - 0xc0000000 ( 16 MB) | |
.init : 0xc0008000 - 0xc0025000 ( 116 kB) | |
.text : 0xc0025000 - 0xc0318000 (3020 kB) | |
.data : 0xc0330000 - 0xc034e200 ( 121 kB) | |
NR_IRQS:192 | |
AT91: 96 gpio irqs in 3 banks | |
Console: colour dummy device 80x30 | |
console [ttyS0] enabled | |
Calibrating delay loop... 197.83 BogoMIPS (lpj=989184) | |
pid_max: default: 32768 minimum: 301 | |
Mount-cache hash table entries: 512 | |
CPU: Testing write buffer coherency: ok | |
NET: Registered protocol family 16 | |
bio: create slab <bio-0> at 0 | |
SCSI subsystem initialized | |
usbcore: registered new interface driver usbfs | |
usbcore: registered new interface driver hub | |
usbcore: registered new device driver usb | |
Switching to clocksource pit | |
NET: Registered protocol family 2 | |
IP route cache hash table entries: 1024 (order: 0, 4096 bytes) | |
TCP established hash table entries: 1024 (order: 1, 8192 bytes) | |
TCP bind hash table entries: 1024 (order: 0, 4096 bytes) | |
TCP: Hash tables configured (established 1024 bind 1024) | |
TCP reno registered | |
UDP hash table entries: 256 (order: 0, 4096 bytes) | |
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) | |
NET: Registered protocol family 1 | |
RPC: Registered udp transport module. | |
RPC: Registered tcp transport module. | |
RPC: Registered tcp NFSv4.1 backchannel transport module. | |
JFFS2 version 2.2. (NAND) © 2001-2006 Red Hat, Inc. | |
msgmni has been set to 56 | |
io scheduler noop registered (default) | |
atmel_usart.0: ttyS0 at MMIO 0xfefff200 (irq = 1) is a ATMEL_SERIAL | |
brd: module loaded | |
ssc ssc.0: Atmel SSC device at 0xc2868000 (irq 14) | |
NAND device: Manufacturer ID: 0x2c, Chip ID: 0xda (Micron NAND 256MiB 3,3V 8-bit) | |
AT91 NAND: 8-bit, Software ECC | |
Scanning device for bad blocks | |
Bad eraseblock 10 at 0x000000140000 | |
7 cmdlinepart partitions found on MTD device atmel_nand | |
Creating 7 MTD partitions on "atmel_nand": | |
0x000000000000-0x000000020000 : "bootstrap" | |
0x000000020000-0x000000060000 : "uboot" | |
0x000000060000-0x000000080000 : "env1" | |
0x000000080000-0x0000000a0000 : "env2" | |
0x0000000a0000-0x0000002a0000 : "linux" | |
0x0000002a0000-0x0000012a0000 : "config" | |
0x0000012a0000-0x000010000000 : "root" | |
atmel_spi atmel_spi.1: Atmel SPI Controller at 0xfffcc000 (irq 13) | |
MACB_mii_bus: probed | |
eth0: Atmel MACB at 0xfffc4000 irq 21 (40:d8:55:19:79:c4) | |
eth0: attached PHY driver [Micrel KS8041] (mii_bus:phy_addr=ffffffff:00, irq=-1) | |
usbmon: debugfs is not available | |
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver | |
at91_ohci at91_ohci: AT91 OHCI | |
at91_ohci at91_ohci: new USB bus registered, assigned bus number 1 | |
at91_ohci at91_ohci: irq 20, io mem 0x00500000 | |
hub 1-0:1.0: USB hub found | |
hub 1-0:1.0: 2 ports detected | |
Initializing USB Mass Storage driver... | |
usbcore: registered new interface driver usb-storage | |
USB Mass Storage support registered. | |
mice: PS/2 mouse device common for all mice | |
i2c /dev entries driver | |
Software Watchdog Timer: 0.07 initialized. soft_noboot=0 soft_margin=60 sec (nowayout= 0) | |
TCP cubic registered | |
NET: Registered protocol family 17 | |
can: controller area network core (rev 20090105 abi 8) | |
NET: Registered protocol family 29 | |
can: raw protocol (rev 20090105) | |
can: broadcast manager protocol (rev 20090105 t) | |
Registering the dns_resolver key type | |
VFP support v0.3: not present | |
Empty flash at 0x001d8e3c ends at 0x001d9000 | |
Empty flash at 0x011b6734 ends at 0x011b6800 | |
Empty flash at 0x0e207890 ends at 0x0e208000 | |
VFS: Mounted root (jffs2 filesystem) on device 31:6. | |
Freeing init memory: 116K | |
Starting logging: OK | |
Ethernet speed set to 10Base-T full-duplex | |
Starting BERG Cloud linkd... | |
Initializing random number generator... read-only file system detected...done | |
Starting network... | |
WARNING: could not read from /sys/class/net/eth0/carrier | |
udhcpc (v1.21.0) started | |
Failed to kill daemon: No such file or directory | |
Sending discover... | |
Sending select for 192.168.178.200... | |
Lease of 192.168.178.200 obtained, lease time 864000 | |
Failed to kill daemon: No such file or directory | |
deleting routers | |
route: SIOCDELRT: No such process | |
adding dns 192.168.178.1 | |
Starting SSH Daemon: dropbear. | |
eth0: link up (10/Full) | |
Sat Sep 1 12:00:00 UTC 2012 | |
Getting initial time via ntp. | |
Starting network time protocol daemon: ntpd. | |
Remounting RW | |
Welcome to Linux (BERG Cloud Bridge) | |
berg-cloud-bridge-p9tsns3wk login: | |
Script done on Mon May 25 12:55:46 2020 |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment