This is an initiative to create an overview of the issues found with the Creality CR-6 SE.
As of this writing (2020-09-19) the large number of the motherboard issues have not been publicly acknowledged. Hopefully this overview forces Creality to acknowledge the issues with the Creality CR-6 SE leveling free 3d printer.
According to Creality all issues should be resolved in the newer models:
Here are the improvements we did as below:
With most of the CR-6 SE issues being due to bad wiring or loose/too tight screws I feel like it is time for a good post-unboxing checklist, to be walked through pre-assembly. Even though I do not have my unit shipped yet, I've seen enough issues and fixes that I can compile this post.
I initially posted this on the independent CR-6 community Facebook group but since not everyone wants to use Facebook (which I totally understand), I will repost it here. I mirrored most of the relevant content of Facebook to imgur.
If you have any feedback or anything that needs to be added, please let me know and I will amend this post!
Note: There are some known issues with this printer - please read the entire guide. (It is long, I know, but this is a necessary evil!)