Skip to content

Instantly share code, notes, and snippets.

View solf1re2's full-sized avatar

solf1re2 solf1re2

View GitHub Profile
@utlandr
utlandr / biqu_microprobe.cfg
Last active June 3, 2024 13:22
Klipper probe config for the BIQU Microprobe (V1/V2)
## --- BIQU Microprobe Klipper configuration ---
# Not much different from a standard probe config. The
# main difference compared to most probes is to disable
# deactivating the probe (PROBE_UP) after each sample
#
# You can either copy pasta this directly or import
# into your config.yml using [include microprobe.cfg]
#
# Note: if you are changing from a bltouch or one of its
# clones, remove/comment out the [bltouch] config!
@bistory
bistory / Klipper Anycubic i3 Mega
Last active May 6, 2024 09:53
Anycubic i3 Mega configuration for Klipper (with TMC2209 + SPI, BMG extruder with stock motor, pressure advance and BLTouch clone)
# This file contains pin mappings for the Anycubic i3 Mega with
# Ultrabase from 2017. (This config may work on an Anycubic i3 Mega v1
# prior to the Ultrabase if you comment out the definition of the
# endstop_pin in the stepper_z1 section.) To use this config, the
# firmware should be compiled for the AVR atmega2560.
# See the example.cfg file for a description of available parameters.
[stepper_x]
step_pin: PF0