ExtremeGTX

Introduction

This tutorial for setting up Ubuntu Server (RPi 3B) as Wifi access point

Overview:

The main steps can be listed as following:

1. Install required packages
2. Setup hostapd
3. Setup DNSmasq
4. Configure AP IP Address

dogrocker

#Wireless Penetration Testing Cheat Sheet

##WIRELESS ANTENNA

• Open the Monitor Mode

root@uceka:~# ifconfig wlan0mon down
root@uceka:~# iwconfig wlan0mon mode monitor
root@uceka:~# ifconfig wlan0mon up

bjoern-r

HOWTO use a Huawei E3372 on OpenWRT

This modem is also sold as a MegaFon M150-2 USB dongle

Needed Software

Install the needed packages via opkg tool

opkg update

Lewiscowles1986

#!/bin/bash
#
# This version uses September 2017 august stretch image, please use this image
#

if [ "$EUID" -ne 0 ]
	then echo "Must be root"
	exit
fi

DraTeots

Connecting to serial port (com port) over network

(Serial port or com port? - Serial ports are often refered as COM ports. It is the same to be short. You can read abut it in the Wiki article )

• The problem
• The solution in theory
• WINDOWS
  • Server
  • Client

• Driver Signature

probonopd

#include <IRremote.h>

/*

 Send infrared commands from the Arduino to the iRobot Roomba
 by probono
 
 2013-03-17 Initial release
 

mschmitt

/*

  A trivial Arduino sketch to mimic iRobot Virtual Wall for Roomba
  ----------------------------------------------------------------

  Based on information found at:
  http://sites.google.com/site/irobotcreate2/createanirbeacon
  
  Uses "A Multi-Protocol Infrared Remote Library for the Arduino":
  http://www.arcfn.com/2009/08/multi-protocol-infrared-remote-library.html