- BeagleBone Blue
- 3D printed BeagleBone Blue case
- Martian II 220mm frame
- Racerstar RS20Ax4-V2 Quad electronic speed control
- Racerstar motors
- Props
- 2S LiPo battery
- XT60 socket
- DSM transmitter
- DSM satellite receiver
- 4-wire JST-SH cable
- velcro
- wires, solder and soldering iron
- heat-shrink tubing and hot air gun
The motors should be configured as "Quad X" where BeagleBone Blue's USB connector is forward-facing.
- yellow
- orange
- green/black
- blue
- Started with https://beagleboard.org/p/jkridner/beaglebone-blue-220mm-quadcopter-9801d8. Will eventually add more.
I am having problems with the PRU I've run your setup.sh file and didn't have any errors. I can't find any clear cut documentation on how to enable the PRU. The one step by step post i found bricked my bone and i had to rebuild the SD card.
I'm extremely frustrated with the lack of documentation on the Beagle Bone Blue and that there seems to be no central source for help.
Any advice? The error message i'm getting is posted as well.