leegrey

// Copyright Lee Grey, 2014
// License: MIT

module lg.tileSystem {

	import Vector2D = lg.math.geometry.Vector2D;

	export class FieldInfo {

		distanceFromTarget: number = -1;

IISResetMe

function Get-MachineSID
{
  param(
    [switch]
    $DomainSID
  )

  # Retrieve the Win32_ComputerSystem class and determine if machine is a Domain Controller  
  $WmiComputerSystem = Get-WmiObject -Class Win32_ComputerSystem
  $IsDomainController = $WmiComputerSystem.DomainRole -ge 4

powerman

Asciidoc cheatsheet for GitHub

gbaman

Raspberry Pi Zero OTG Mode

Simple guide for setting up OTG modes on the Raspberry Pi Zero - By Andrew Mulholland (gbaman).

The Raspberry Pi Zero (and model A and A+) support USB On The Go, given the processor is connected directly to the USB port, unlike on the B, B+ or Pi 2 B, which goes via a USB hub.
Because of this, if setup to, the Pi can act as a USB slave instead, providing virtual serial (a terminal), virtual ethernet, virtual mass storage device (pendrive) or even other virtual devices like HID, MIDI, or act as a virtual webcam!
It is important to note that, although the model A and A+ can support being a USB slave, they are missing the ID pin (is tied to ground internally) so are unable to dynamically switch between USB master/slave mode. As such, they default to USB master mode. There is no easy way to change this right now.
It is also important to note, that a USB to UART serial adapter is not needed for any of these guides, as may be documented elsewhere across the int

xem

Conventions

• A = [xA, yA] is a point on the 2D plane. Same for B, C, ...
• lengths are in any unit (ex: pixels)
• code snippets are in JavaScript

Degrees to radians

angleRad = angleDeg * Math.PI / 180;

RandomInsano

#!/usr/bin/env python3

import serial
import binascii

#open serial
ser = serial.Serial(
    port='/dev/tty.usbserial-A6005kdh',
    baudrate=115200,
    timeout=0.005

arrieta

// A simple Lexer meant to demonstrate a few theoretical concepts. It can
// support several parser concepts and is very fast (though speed is not its
// design goal).
//
// J. Arrieta, Nabla Zero Labs
//
// This code is released under the MIT License.
//
// Copyright 2018 Nabla Zero Labs
//

agatsoh

Installing Python 3.7.3 on MX-linux 18.1

I was following this blog to install python 3.7.3 on my MX-linux 18.1 machine. Step by step procedure is as follows

1. Install the pre-requisites

sudo apt-get install build-essential checkinstall
sudo apt-get install libreadline-gplv2-dev libncursesw5-dev libssl-dev \
 libsqlite3-dev tk-dev libgdbm-dev libc6-dev libbz2-dev libffi-dev

JarekParal

python CI/updateVersion.py %NEW_VERSION%
pyinstaller testApp.py --version-file "CI/version.py"

mdouchement

Steam link

Factory reset

Create the file factory_reset.txt with 1 value inside on a FAT32 USB drive and booting the Link with it plugged in.

Enable SSH

Create the /steamlink/config/system/enable_ssh.txt empty file on a FAT32 USB drive and booting the Link with it plugged in.